DIY Short Necklaces

This past week I have become obsessed with short, beaded necklaces. Inspired by gorgeous spring jewellery collections, I encountered two problems: poverty and wanting things immediately. So bring on the DIY.

I bought many of my beads (including those lovely turquoise stones) at my favourite bead store in Toronto, Chaton Beads BUT just this weekend I learned (the hard way) that Chaton Beads is no more. Sadness. Yes, there are a dozen other bead stores on that same block, but this one was The One.

Anyhoo, this DIY is waaay quicker than my other necklaces and adds a lovely pop of colour to any outfit. Also it really doesn't matter what beads you use so if you can't decide, just make several! I set out to only make one, but clearly went overboard. Nothing new here! *blush*

What You Need:

Beads (whatever you like, enough for a 2-3 inch strand)
Fishing line (beading string)
Pliers
Wire cutters
Small crimping beads (Full disclosure: the ones I used were way too big so they turned out quite wonky. I'll likely redo them at some point because I can't deal with wonky.)
Jump rings (4 per necklace)
Chain (2 strands at 8.5 inches each*)
Clasp

The finished necklace measures 19-20 inches, dependent on your beads. *My advice regarding the chain is to always always cut a bit more than you think you need and clip it later once you've tried it on.

Step one. Decide on a pattern. Honestly, this part always takes me ages. AGES.

Cut several inches of your fishing line.

String your crimping bead and a jump ring onto the fishing line. Loop the string back through the crimping bead, leaving a tail. Pull tight, and smoosh the crimping bead shut with your pliers. Your string should be trapped.

String your beads onto the fishing line, tucking the tail through the beads as well, effectively hiding it.

When you come to the end, string your last crimping bead and jump ring on the fishing line and this time when you double back through the crimping bead, string your fishing line through a few beads only and pull the end tight. Smoosh the crimping bead. Trim the tail. (I realize that was a tongue twister.)

You're done the strand! It was so quick and easy that I made several. Whoops.

Using jump rings (and pliers to open and close them), connect your chain strands to the clasp and to your beaded strand.

Wear it.